The Genii Forum

Hello,

I am trying to replace a "washer" style Jardine Ellis Ring. The ring is a flat washer style ring as opposed to the "tubular" style that is available everywhere. The one which I had was purchased in the '70's. Is anyone familiar with this style ring or who manufactured them? There is a similar one listed on ebay made by Sherms, however the hole is not big enough. The center hole should be able to fit over a spectators thumb. Any help with this is appreciated

Sent you a message.

It might be "Wash Off" available at www.porperoriginals.com check it there.

http://geniimagazine.com/forum/cgi-bin/ ... 4;t=007926

The Johnson made is as you described.

Mike

Sasco made a flat brass jardine ellis ring about 1/4 in with a 1 1/2 in opening.

Steve